| Measurement |
Number of units: 1
Input type: 2-lead, ground referenced
Input resistance: 100 kW or 10 kW
Maximum operating input voltage: 60 V
Absolute maximum input voltage: 100 V - WARNING - voltages between 60 V and 100 V will not damage the instrument but could result in personal injury or damage to other instruments
Update rate: 5 rdg/s display; 30 rdg/s IEEE-488; 30 rdg/s serial |
| |
| DC |
DC resolution: To 5¾ digits
DC integrator capacitance: 1 µF nominal
DC input resistance: 100 kW 10 kW
DC ranges: 300 mVs, 30 mVs, 30 mVs, 3 mVs
DC resolution: 0.001 mVs, 0.0005 mVs, 0.0005 mVs, 0.0005 mVs
DC accuracy: Offset: ±10 µVs ±DC integrator drift; Gain: ±0.25% of reading (<10 Vs/s maximum rate of change)
DC minimum dF/dt: 20 µVs/min
DC maximum dF/dt: 60 Vs/s
DC integrator drift: ±1 µVs/min, 0.0004% FS/min on 300 mVs range
(100 kW input resistance constant temperature environment) |
| |
| DC Peak |
DC peak resolution: 4¾ digits
DC peak integrator capacitance: 1 µF nominal
DC peak input resistance: 100 kW 10 kW
DC peak ranges: 300 mVs, 30 mVs, 30 mVs, 3 mVs
DC peak resolution: 0.01 mVs, 0.001 mVs, 0.001 mVs, 0.001 mVs
DC peak minimum reading: 0.05 mVs, 0.005 mVs, 0.005 mVs, 0.005 mVs
DC peak accuracy: Offset: ±100 µVs ±DC integrator drift; Gain: ±5% of reading (<10 Vs/s maximum rate of change)
DC peak maximum dF/dt: 60 Vs/s
DC peak update rate: Reduces update rate to ¼ normal |
| |
| AC |
AC resolution: 4¾ digits (reduced to 3¾ digits on the 30 µVs range)
AC integrator capacitance: 0.1 µF nominal
AC input resistance: 100 kW
AC ranges: 30 mVs, 3 mVs, 300 µVs, 30 µVs
AC resolution: 0.001 mVs, 0.0001 mVs, 0.01 µVs, 0.01 µVs
AC minimun rdg: 3.000 mVs, 0.3000 mVs, 30.00 µVs, 3.00 µVs
AC frequency response: 2 Hz to 50 kHz
AC accuracy: ±1% rdg ±10 µVs (10 Hz to 10 kHz sinusoidal); ±5% rdg
±10 µVs (2 Hz to 50 kHz sinusoidal)
AC integrator drift: NA |
| |
| AC Peak |
AC peak resolution: 3¾ digits
AC peak integrator capacitance: 0.1 µF nominal
AC input resistance: 100 kW
AC peak ranges: 30 mVs, 3 mVs, 300 µVs
AC peak resolution: 0.01 mVs, 0.001 mVs, 1 µVs
AC minimun reading: 0.01 mVs, 0.001 mVs, 5 µVs
AC peak accuracy: ±5% rdg ±10 µVs (10 Hz to 10 kHz sinusoidal);
±10% rdg ±10 µVs (2 Hz to 50 kHz sinusoidal)
AC peak update rate: Reduces update rate to ¼ normal |
|
| Front Panel |
Display type: 2 line × 20 character, vacuum fluorescent display
Display resolution: To ±5¾ digits
Display update rate: 5 rdg/s
Display units: Vs, MxN, WbN, VsF, MxF, WbF, G, T, Wbcm, A, %
Units multipliers: p, n, µ, m, k, M, G
Annunciators: AC – AC input signal, DC – DC input signal, ∧ ∨ – Positive and negative peaks, R – Remote operation, :Alarm on
Keypad: 21 full travel keys |
| |
| Interfaces |
| IEEE-488.2 capabilities: SH1, AH1, T5, L4, SR1, RL1, PP0, DC1, DT0, C0, E1 |
| Serial interface: RS-232C electrical, DA-9 connector, 9600 BAUD |
| External reset type: Contact closure |
| Alarms |
| |
Number: 2 |
| |
Settings: High and low set point, Inside/Outside, Audible |
| |
Actuators: Display annuciator, beeper, relays |
 |
 |
|
| Relays |
| |
Number: 3 |
| |
Contacts: Normally open (NO), normally closed (NC), and common (C) |
| |
Contact rating: 30 VDC at 2 A |
| |
Operation: Follow high, low alarms with third relay indicating no alarm state - can be operated manually |
| |
Connector: Detachable terminal block |
 |
 |
|
| Monitor analog output |
| |
Scale: ±3 V = ±FS on Vs range |
| |
Accuracy: ±1% of reading ±10 mV, (DC to 10 kHz); ±5% of reading ±10 mv, (10 kHz to 50 kHz) |
| |
Minimum load resistance: 1 kW |
| |
Connector: Detachable terminal block |
 |
 |
|
| Corrected analog output |
| |
Scale: User selected |
| |
Range: ±10 V |
| |
Resolution: 0.3 mV |
| |
Accuracy: ±2.5 mV |
| |
Minimum load resistance: 1 kW |
| |
Connector: Detachable terminal block |
 |
 |
|
| |
| General |
Ambient temperature: 15 ºC to 35 ºC at rated accuracy; 5 ºC to 40 ºC with reduced accuracy
Power requirement: 100, 120, 220, 240 VAC, +5%, -10%, 50 or 60 Hz, 20 VA
Size: 216 mm W × 89 mm H × 318 mm D (8.5 in × 3.5 in × 12.5 in), half rack
Weight: 3 kg (6.6 lb)
Approval: CE mark |
| |
|